Large scale kiln dust collector

The working characteristics of a lime kiln determine its lifelong association with dust particles, which is determined by its genes. Of course, by improving it in the later stage and adding some equipment, it will reduce the amount of dust and be helpful for the safety of the entire kiln and operators. Below, you can briefly understand the operation of the dust collector in medium and large kilns.

1. The inlet and outlet of the large-scale kiln dust collector are equipped with regulating valves, which can achieve non-stop maintenance and bag replacement.

2. Transforming the design of ventilation from a single profession to a joint design and supervision by multiple professionals in ventilation, steel structure, welding, mechanical, electrical, etc., the advantages of each profession are concentrated on the design of large-scale kiln dust collectors, making the overall structure reasonable. Not only is the frame, box, beam and column of large-scale kiln dust collectors subjected to reasonable pressure, tension, and torque, but each member and support works under good stress conditions, fully considering active loads and seismic cracking, so that the overall design can meet the needs of working conditions.

Material selection

1. The material and structure of the wall panel of the large kiln dust collector ensure a pressure resistance of ≥ 6000Pa and a leakage rate of ≤ 3%.

2. The flower board is made of Q235 steel plate with a thickness of 5mm.

3. The filter material is Flumex, which is resistant to a temperature of 250 ℃.

4. The design, material selection, and production of pipelines and platforms, drawings, escalators, and pedals for large-scale kiln dust collectors shall be carried out in accordance with national standards and relevant design specifications.

5. The design, material selection, and production of the air bag shall be carried out in accordance with national standards and relevant design specifications.

6. High quality products are selected for pulse valves and solenoid valves.

7. The supporting components adopt standardized components and standardized equipment components to meet the needs of users for replacement.

8. Equipment welding components should strictly comply with relevant national welding standards. Perform visual inspection and corresponding non-destructive testing based on the importance of the components.

9. Each component and part of the equipment should be equipped with lifting ears or holes as needed.

10. The pneumatic flap valve can be opened and closed flexibly, in place, and without any air leakage.

Traditional kilns can no longer adapt to the current socio-economic development, which poses a threat to the safety of workers, the production efficiency and quality of lime kilns. We must keep up with the pace of the times and keep up with the times.